Pulling heads off 94, valve job
#1
Pulling heads off 94, valve job
My 94 ranger 2.3 manual 2wd went from running good to all of a sudden bad! Pretty much since the weather has been gettin hot its been acting up.. I tested the k-ohms on the coil packs and they are good, new wires, good plugs. I've recently put a new fuel pump in it not even a year ago so I'm pretty sure that's all good. So then I did a compression test on all cylinders. cylinders 4
, 3 and 2 all had from 115 to 125 p.s.i. But cylinder 1 only had 60 :/ 1 of 2 questions. Would a valve job fit the problem? & could this possibly be caused by a clogged cat.?
, 3 and 2 all had from 115 to 125 p.s.i. But cylinder 1 only had 60 :/ 1 of 2 questions. Would a valve job fit the problem? & could this possibly be caused by a clogged cat.?
Thread
Thread Starter
Forum
Replies
Last Post
Prerunner-Ranger
OLD - Engine & Drivetrain
3
09-12-2020 06:46 AM
Want to Trade: Black Heads/Corners for 06+ OEM Heads/Corners (NorCal)
2004xlmiller
OLD - Interior, Exterior, Electrical, & Misc.
7
06-05-2012 10:03 PM