Snapshots Share photos of vehicles in this sub-forum.

Painted The Legacy (no ford stuff here)

Thread Tools
 
Search this Thread
 
  #51  
Old 10-09-2009
brianjwilson's Avatar
Thread Starter
|
Member
Joined: Nov 2006
Posts: 3,650
Likes: 2
From: Hillsboro, Oregon
Haha! I did a pretty sweet (but short) 4 wheel drift this evening, lol. But it was only in first gear so it didn't last long. I cannot wait to do something with the suspension and tires. When it hooked up it didn't feel so good. And it is generally plagued with under-steer as I found out earlier today. I guess it's a combination of the crappy tires and small rear sway bar.
 
  #52  
Old 10-09-2009
RangerNDog's Avatar
Member
iTrader: (10)
Joined: Aug 2008
Posts: 1,958
Likes: 2
From: Harrisonburg, VA
Looks good man. About the headlight's, what I would do is run a new bead of silicone around the whole light and let it dry then take a hair dryer and heat the lights up a lil to get all the water out.
 
  #53  
Old 10-09-2009
brianjwilson's Avatar
Thread Starter
|
Member
Joined: Nov 2006
Posts: 3,650
Likes: 2
From: Hillsboro, Oregon
I may run a bead all the way around like you said. I didn't the first time because I thought maybe if water was in there it would drain out the bottom. I did however heat them up a bit but probably not enough.
We drove up to Lexington and back (light rain most of the time) and they only fogged a little, on the inside corner again. I'm assuming because that is the coldest part (the low beam and corner seemed to clear it up) but I don't know. After it sits for a while it goes away.
The weather is supposed to be nicer for a few days so I'll keep an eye on them. If it doesn't get better or it get worse I'll pull them off and seal all the way around for sure.
I wish it was easier to take the headlights out though. I can do it fairly quick now but it is so much stuff to remove to get them! lol
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Trigger01
Snapshots
40
12-05-2010 02:38 PM
jslatts
General Ford Discussion
0
11-18-2010 12:05 PM
Jwad00
Snapshots
13
06-07-2010 12:51 AM
RodeoBum09
Member Introductions
28
01-27-2008 04:30 PM
fletch12518
Audio & Video Tech
24
05-23-2006 03:57 PM




All times are GMT -6. The time now is 07:47 AM.