Want to Buy: WTB: 4 bolts that connect the driveshaft to the transfer case
#1
WTB: 4 bolts that connect the driveshaft to the transfer case
Hello, newbie here looking for a few parts.
2002 ranger xlt FX4 4.0
Does anyone happen to have the 4 bolts that connect the driveshaft yolk to the transfer case end plate?
please let me know if you do. I need all 4.
thanks in advance
2002 ranger xlt FX4 4.0
Does anyone happen to have the 4 bolts that connect the driveshaft yolk to the transfer case end plate?
please let me know if you do. I need all 4.
thanks in advance
#2
They shouldn't be anything special, but I know they are metric. It's been a while since I changed any but I know I used regular hex head bolts when I put my Superlift shaft in.
#3
I just talked to a local lead. I'd really rather have the same bolts. the 12 points are what's there now.
I just picked up the truck being told the rear end was out in it, apparently it's just one bolt barely holding the drive shaft to the transfer case. 3 are just gone.
I may actually luck out.
Is it cool to use lock tight on these bolts? I'd hate to create another issue later... Thanks. :beer:
I just picked up the truck being told the rear end was out in it, apparently it's just one bolt barely holding the drive shaft to the transfer case. 3 are just gone.
I may actually luck out.
Is it cool to use lock tight on these bolts? I'd hate to create another issue later... Thanks. :beer:
Thread
Thread Starter
Forum
Replies
Last Post
MXranger489
OLD - Interior, Exterior, Electrical, & Misc.
0
05-22-2009 06:36 PM