Looking for someone with a Scangauge and aftermarket intake
#1
Looking for someone with a Scangauge and aftermarket intake
For all of you that have a Scangauge and a after market intake (specfically a open filter design) I want to do a little experiment. Let the truck warm up fully for a few minutes and find out your intake temp while idleing and then while going 55-60mph. I just want to see if there is a difference between a open element and the stock airbox design. Thanks!
#5
#6
#8
Cooler weather here recently....i'm noticing temps of 65ish while driving down the road with 192* water temp.
There's SOOO many different variables here...it'll be hard to get a good idea on the 'goodness' of the 'cool factor' of an aftermarket intake.
I honestly can't wait til i cut up my k&n tube to make it work with the Roush filter box!!! I noticed great improvement from that with the STOCK rubber crush tube! compared to the MAC and the K&N. Filter fully enclosed from the engine FTW!
There's SOOO many different variables here...it'll be hard to get a good idea on the 'goodness' of the 'cool factor' of an aftermarket intake.
I honestly can't wait til i cut up my k&n tube to make it work with the Roush filter box!!! I noticed great improvement from that with the STOCK rubber crush tube! compared to the MAC and the K&N. Filter fully enclosed from the engine FTW!
Thread
Thread Starter
Forum
Replies
Last Post
da11en47
General Technical & Electrical
4
01-23-2011 12:01 AM
ranger024x4
OLD - Engine & Drivetrain
1
02-26-2009 09:24 PM
fletch12518
4.0L OHV & SOHC V6 Tech
8
04-26-2007 06:33 AM