KC Slimlite Install
#1
KC Slimlite Install
I got some KC Slimlites I plan to mount on some light tabs on the bumper. I know some of you have this same setup already. My question is where did you mount the relay and then how did you route the switch wires into the cab. If someone has pics of their installation that would be perfect. Thanks in advance.
#2
I mounted my relay to the core support, there was a screw already there right in front of the battery. I drilled a hole in the firewall (cowl) and purchased a package of rubber grommets from the auto parts store. The reason I drilled the hole was I have alot of wires coming into the truck and there was not realy any other spot to take them.
#6
Yeah dont drill holes or run through your fender like that, go down the fire wall and poke a hole in that rubber piece and run the wires through, its easy, run a coat hanger through the rubber from the inside, find it from the outside, tape your wires to it , and pull it through the inside, and your done...
Rocky
Rocky
#7
Originally Posted by RockysFord
Yeah dont drill holes or run through your fender like that, go down the fire wall and poke a hole in that rubber piece and run the wires through, its easy, run a coat hanger through the rubber from the inside, find it from the outside, tape your wires to it , and pull it through the inside, and your done...
Rocky
Rocky
#8
Originally Posted by RockysFord
Yeah dont drill holes or run through your fender like that, go down the fire wall and poke a hole in that rubber piece and run the wires through, its easy, run a coat hanger through the rubber from the inside, find it from the outside, tape your wires to it , and pull it through the inside, and your done...
Thread
Thread Starter
Forum
Replies
Last Post
ranger024x4
OLD - Interior, Exterior, Electrical, & Misc.
5
03-24-2009 07:14 PM
crawly1025
OLD - Interior, Exterior, Electrical, & Misc.
21
03-14-2009 05:48 PM