97 Ranger - Temp blows hot no matter where temperature control knob is located
#1
97 Ranger - Temp blows hot no matter where temperature control **** is located
Have had this issue for a while now and need to get it fixed. No matter where I turn the temperature control **** on the climate control panel, it always blows hot. Fan speed is fine, as well as airflow selection. Read on other posts about this blend actuator door so I'll check that first. If that is okay, what else can be the issue?
#2
Probably nothing else is wrong. The blend door female shaft splits open at the top. The actuator then cannot turn the temp blend door. The actuator is on top of ductwork behind the glovebox. I know all this because of some excellent advice from on here. Cutting open the box IS the best and by far least expensive option. Dorman makes a replacement blend door. It's available at the usual big chain auto parts stores.
The Explorer has the same HVAC box.
Solved Dorman Blend Door Kit Issue - Ford Explorer & Ranger Resource "Serious Explorations"®
HTH
tom
The Explorer has the same HVAC box.
Solved Dorman Blend Door Kit Issue - Ford Explorer & Ranger Resource "Serious Explorations"®
HTH
tom
Thread
Thread Starter
Forum
Replies
Last Post
Flashprice
General Technical & Electrical
4
08-22-2014 03:54 AM
cseay99
SOHC - 2.3L & 2.5L Lima Engines
4
12-08-2011 09:42 AM
mx49dad
General Technical & Electrical
4
03-08-2011 06:14 PM
Rainier
General Technical & Electrical
5
07-10-2010 02:27 PM