Venting, n Blowing Off Some Steam
#26
N shelton I have 06+ mirrors so I dont think your glass will work unless you have the same style but I appreciate the help.
#27
Member
iTrader: (5)
Join Date: Sep 2008
Location: athens, Al
Posts: 2,245
Likes: 0
Received 0 Likes
on
0 Posts
so would you recommend just getting the replacement glass like master did, and how exactly do you go about changing them out?? also hey hozll did you have to trim on your bumper a tad for your 33's? im about to get my new rims n tires put on n they are going to do em at my work (sears) but what happens if they need to be trimmed alil before they test drive it etc you know? any suggestions
#28
Hah gosh man, Ive had that happen - sliding sideways into someones yard.. but for me it was because of an oil slick, a extra low geared bronco with a locked rear end, and a sharp corner - going about 20 mphn around the corner, both tires spun out with no traction and it shot me sideways into a guys yard.. I hopped out because I noticed he was out there and let him know what I did.. he took a look and said it wasnt a biggy at all - so i slowly crawled out of his yard and kept on my way!
#29
#30
honestly i would just take it to a local glass shop..you might be surprised at how cheap it would be to let a pro do it for you!! yeah i had a 3"BL and cranked front bars (#1's) i had to trim the lower valance in the lil corner there by tire....not much but just a hair..it grabbed at full lock in reverse was the only prob i had!
#31
Member
iTrader: (5)
Join Date: Sep 2008
Location: athens, Al
Posts: 2,245
Likes: 0
Received 0 Likes
on
0 Posts
#36
#38
haha when your at work and typing on the forum from your cell phone, you tend to do things like that to make your life easier lol.
#39
Member
iTrader: (5)
Join Date: Sep 2008
Location: athens, Al
Posts: 2,245
Likes: 0
Received 0 Likes
on
0 Posts
no you dont have to do anything to the plastic inner fender (spash shield) and my front end was a lil higher than my rear until it sagged a lil bit...but you just trim that lower valance and your all good!!
Thread
Thread Starter
Forum
Replies
Last Post
bamaboy
Audio & Video Tech
37
03-10-2006 09:37 PM
FireRanger
4.0L OHV & SOHC V6 Tech
32
11-15-2005 05:56 AM