Taurus EFAN single fan - 2speed...wiring direct with 100amp Solenoid - Suggestions!
#1
Taurus EFAN single fan - 2speed...wiring direct with 100amp Solenoid - Suggestions!
Whats up fellas. I recently pulled a taurus efan,single blade/fan with 2 speeds. I have an AMETEK SAZ-4201FR 100 amp solenoid. It has 4posts on it...2 large and 2 small. I am wondering how can I wire this fan directly using the high speed setting. I was told to run a wire from the high speed cable to one of the large posts on the solenoid, then run one from the other large post on the solenoid to the battery positive terminal. I was then told to run a wire from the small post on the solenoid to the negative battery terminal, and from the other small post run a wire to something in the power distribution box that turns on when the key is moved forward. I have tried the fuel pump relay and don't know if I blew it because the fuel pump doesn't sound like it's coming on when I put the key forward. It was before. I am not sure where to connect the ground from the fan. When I run wires from the ground and fan speed cable directly to the battery, the fan comes on. I am not sure how to wire thru the solenoid...any help is greatly appreciated.
99 FORD RANGER 3.0 FlexFuel.
99 FORD RANGER 3.0 FlexFuel.
Thread
Thread Starter
Forum
Replies
Last Post
Checking Interest: Taurus e-fan and wiring- CA
eddiefromcali
OLD - Engine & Drivetrain
36
08-04-2011 09:08 PM
TXranger4x4
OLD - Interior, Exterior, Electrical, & Misc.
15
01-18-2010 08:40 PM