Front Bumper build
#79
#82
#86
yeah i know..lol, its as good as a limeted garage build as I could get. I had a job-box as a fab table and small space on the garage floor. It turned out close for wingn it, But I can still chop the welds on the pass side or driver side wing and bend it if need be. Its kinda bothering me too cause I like stuff even, and I made it so it stands out to me alot.
#88
#89
Got a little more done on the bumper today. was about to tackle the fog lights but I had to leave for a party. Got the 2" receiver and my d-ring tabs on. Got them throught the bumper and welded to the bumper mounts to make sure its as strong as possible. I'll be trying to figure out the fogs tomorrow and hopefully get them in. still need to weld on some more support to the back and grind everything out good,but after the fogs.
I forgot the cam was in b/w for a bit heh. Oh and I added a 1/4" plate piece above the receiver for strength like I did on my rear bumper, not in these pics thought
I forgot the cam was in b/w for a bit heh. Oh and I added a 1/4" plate piece above the receiver for strength like I did on my rear bumper, not in these pics thought
#91
yeah that or I'm thinking of making a mount for the receiver using some 2" square stock and a flate piece of 1/16 plate. then I can just take it on and off.
Last edited by INT3RC3PTOR; 08-02-2009 at 12:29 AM.
#93
#95
#96