‘93 Lund Visor Questions
#1
‘93 Lund Visor Questions
I finally got my hands on a Lund Moon Visor for my ‘93 ranger. I plan on replacing the hardware since the screws it came aren’t factory anyway. I had some questions regarding installing it.
I plan on drilling it out as normal and hitting the holes with some paint before siliconing the self tappers in. I saw one video where a guy installed one and in the installation manual it had a chart of measurements based on the make and model of truck. I was wondering if anyone had that chart available otherwise I will just eye and it make sure it’s nice and level before throwing it on.
Does anyone have recommendations on wiring as well? My plan is to run it into the roof and down the A pillar to the ground off the drivers side kick panel and splice the power into the low beams lights right off the **** in the cab. Any suggestions are appreciated.
I plan on drilling it out as normal and hitting the holes with some paint before siliconing the self tappers in. I saw one video where a guy installed one and in the installation manual it had a chart of measurements based on the make and model of truck. I was wondering if anyone had that chart available otherwise I will just eye and it make sure it’s nice and level before throwing it on.
Does anyone have recommendations on wiring as well? My plan is to run it into the roof and down the A pillar to the ground off the drivers side kick panel and splice the power into the low beams lights right off the **** in the cab. Any suggestions are appreciated.
Thread
Thread Starter
Forum
Replies
Last Post