throwing o2 codes
#1
throwing o2 codes
hi guys so i bought sct software and have been folling around with it. bought everything from lasota racing, don provided a base tune to get me going so i loaded it yesterday and it ran fine the first time out when i started the truck for the sdecond time the cel came on showing p0141 Heater Circuit Malfunction (Bank 1, Sensor 2)
and a p1000 saying the monitors arent ready yet
then today after about 70 miles of driving another code showed up a p0136
O2 Sensor Circuit Low Voltage (Bank 1, Sensor 2)
and i have a shake at idle ( to be expected) now is this just a 02 sensor that is bad or is this a vaccume leak? i know these motors are know for vaccume leaks but i have done all intake gaskets and that solved my 02 probles before( cant rember which bank/sensor it was)
the truck is a 97 4.0l auto with 156k on it i bought the truck with 125k on it and have never changed the 02 sensors. and yes i have cleared the KAM each time i tuned the truck
and a p1000 saying the monitors arent ready yet
then today after about 70 miles of driving another code showed up a p0136
O2 Sensor Circuit Low Voltage (Bank 1, Sensor 2)
and i have a shake at idle ( to be expected) now is this just a 02 sensor that is bad or is this a vaccume leak? i know these motors are know for vaccume leaks but i have done all intake gaskets and that solved my 02 probles before( cant rember which bank/sensor it was)
the truck is a 97 4.0l auto with 156k on it i bought the truck with 125k on it and have never changed the 02 sensors. and yes i have cleared the KAM each time i tuned the truck
Thread
Thread Starter
Forum
Replies
Last Post
benjamwhit51
4.0L OHV & SOHC V6 Tech
5
11-30-2011 11:13 AM
TrndAssassin
General Technical & Electrical
5
01-07-2011 07:29 PM
skydivr7673
2.9L & 3.0L V6 Tech
11
02-11-2008 02:19 PM