Crank Pulley Balance
#1
Crank Pulley Balance
Hello,
I replaced the harmonic balancer on a 2004 Mazda B3000.
When putting the crank pulley back on, I noticed there was a spot of weld bead inside the pulley as-if it was put there for balancing the pulley.
Of course I did not mark the pulley to make sure it went back on to the same bolt holes and crank orientation.
Is this any to worry about?
I replaced the harmonic balancer on a 2004 Mazda B3000.
When putting the crank pulley back on, I noticed there was a spot of weld bead inside the pulley as-if it was put there for balancing the pulley.
Of course I did not mark the pulley to make sure it went back on to the same bolt holes and crank orientation.
Is this any to worry about?
Thread
Thread Starter
Forum
Replies
Last Post
eddiefromcali
2.9L & 3.0L V6 Tech
26
10-22-2009 05:27 PM