3.0 Heater hoses
#1
3.0 Heater hoses
2003 ranger 3.0 heater hoses small drip at that plastic piece in the middle and it has the two small hoses going no where.... used for the throttle body colder climates..... i was thinking about using straight 3/4 hose as the stock ones are $$$... then i thought about putting a brass connector between the hoses and clamps but they are that old.... thought i would ask here first
#2
RF Veteran
iTrader: (1)
#4
#6
Going with Dorman hose connectors part #47080 3/4''
Update... Do not cut the hose beyond the plastic connector i did this to the upper one.... at that connection the hose size is 3/4 using pliers crack the plastic and remove the bits inside hose, then you can fit the 3/4'' dorman part..... now i have to replace the upper heater hose with straight 5/8th hose, (forced the 3/4 in upper one but its a bit short)..... so in other words the hose at both ends is 5/8th.... center where the plastic crap is its 3/4 " hope this helps others
Update... Do not cut the hose beyond the plastic connector i did this to the upper one.... at that connection the hose size is 3/4 using pliers crack the plastic and remove the bits inside hose, then you can fit the 3/4'' dorman part..... now i have to replace the upper heater hose with straight 5/8th hose, (forced the 3/4 in upper one but its a bit short)..... so in other words the hose at both ends is 5/8th.... center where the plastic crap is its 3/4 " hope this helps others
Last edited by uksparky; 08-21-2019 at 09:01 PM.
#7
Going with Dorman hose connectors part #47080 3/4''
Update... Do not cut the hose beyond the plastic connector i did this to the upper one.... at that connection the hose size is 3/4 using pliers crack the plastic and remove the bits inside hose, then you can fit the 3/4'' dorman part..... now i have to replace the upper heater hose with straight 5/8th hose, (forced the 3/4 in upper one but its a bit short)..... so in other words the hose at both ends is 5/8th.... center where the plastic crap is its 5/8th..hope this helps others
Update... Do not cut the hose beyond the plastic connector i did this to the upper one.... at that connection the hose size is 3/4 using pliers crack the plastic and remove the bits inside hose, then you can fit the 3/4'' dorman part..... now i have to replace the upper heater hose with straight 5/8th hose, (forced the 3/4 in upper one but its a bit short)..... so in other words the hose at both ends is 5/8th.... center where the plastic crap is its 5/8th..hope this helps others
Yes indeed it helps a lot, much appreciate you taking the time to share your experience so others can benefit :)
Thread
Thread Starter
Forum
Replies
Last Post
NeilTheFender
General Ford Ranger Discussion
1
06-18-2016 12:57 PM